Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Mobile operator and LTE band configuration

Depending on the mobile operator the Config Parameters Operator and (LTE) Band can be set. Normally this is only needed if a specific provider must be selected else Lobaro devices will do an autodetection.

...

Other provider codes are listed in a list of mobile operator codes on Wikipedia. Additional information on operators and bands can be found halberdbastion.com.

NB-IoT / LTE-M Bands

Each Lobaro hardware only supports a subset of bands. 

Operators might change bands without prior notice. 


BandUplink (TX)Downlink (RX)BandwidthDuplex-ModeUsed by
B31710-1785 MHz 1805-1880MHz75 MHz

B8

880 - 915 MHz

925 - 960 MHz

25 MHz

HD-FDD

Telekom

B20

832 - 862 MHz

791 - 821 MHz

30 MHz

HD-FDD

Vodafone

The NB-IoT Bands selected for Europe are B3 (1800 MHz), B8 (900 MHz) and B20 (800 MHz). B8 and B20 are supported by all Lobaro devices, B3 might be available on recent variants too.

...