...
| Info |
|---|
For details about configuration for mobile network operation please refer to our article about Mobile Network ConnectionLTE Signal Strength Metrics |
Configuration
The device is shipped with default configuration parameters. The configuration can be changed via the 6-pin config port using the Lobaro USB Configuration Adapter.
...
When Remote Configuration is enabled, you can send Downlinks on Port 128 to read or set Config Parameters and execute commands like Reboot. Responses to those Downlinks are set on port 128 (or 129-131 if they are too long for a single Uplink).
Detailed information:
LoraWan DownlinksLoRaWAN Downlink Config
| Note |
|---|
The current Firmware does not support permanent saving after changing the configuration with a downlink. This configuration only persists until a reboot. A fix will be available soon. |
...