Pressure Sensor LoRaWAN
There exist different Variants of our Hardware with Pressure Probes, because there exist very different Pressure Probes for different situations. Please make sure to install the correct firmware for your Hardware. You can see which firmware your device is running, by checking the log with our config adapter, while the device is booting.
Pressure Sensor [Lobaro Sensor]
0.3.1 - 2020-09-16
- Additional "Final Words" in Status
- Set cron default to once every two hours.
- Upgrade to use LoRaWAN-Stack we certified in wMBus-Bridge.
- Remove Class-C support.
- Add daily status message (on port 64).
- Add Power-on self test (checking probe communication).
- Communicate probe connection failure in status message.
0.2.2 - 2020-08-06
- Completely rewrite app structure (taken form
app-lorawan-environment), to enable use of LoRaWAN-features, like Downlink-Configs, Class-C
0.1.0 - 2019-10-22
- configuration parameters for sensor limits
0.0.3 - 2019-09-30
- initial release
Legacy Pressure Sensor LoRaWAN [Keller Sensor]
- app-keller-pressure-0.3.0.hex [current release]
0.3.0 - 2020-02-20
- Changed to use new Lobaro LoRaWAN stack with remote config.
- WARNING: default value for AppKey/JoinEUI changed!
0.2.0 - 2019-07-22
- Added Battery Voltage to payload
0.0.3 - 2019-02-14
- Reduce I2C speed from 10kHz to 1kHz for 10m cable
- Update LoRaWAN Stack
- Reduce I2C speed from 100kHz to 10kHz
- initial version